Laser Designator use?

[Scarophion]

Hey guys,
I'm just a little curious as to how the laser designator works. I tried it once with the editor, but that was about 2 years ago and I haven't touched the editor since
I think I had an A10 LGB and a Black OP (controlled by me). Pretty sure that I waypointed the A10 to destroy some tanks, and I targetted them with the laser. Not completely sure though.

So if anyone knows the proper way to do this, please tell me

[Marvin]

I noticed, if you place chopper in editor (AH1), and start to target ground with your laser infront of him, AH1 starting to shoot at the ground, where the red dot placed, i`m shure that he shout out all rockets what he have, on the point where i was targeting!

[bedges]

read this.

[sharkyjoe]

Also, in addition Bedges link you may want to Look at SnYpirs Sp/Mp pack. Found here in the Editors Depot under Mod Editing.
"The laser designator can be used to select a target location instead of the map (the system automatically detects when the designator is designating)."

Using his support Pack in mission making may go a long way in helping you Out!

[Scarophion]

Thanks a lot guys. I'll have to give it a thorough read and get back into scripting ;D

[456820]

and that Bis mission erm laser i think anyway unpbo it and have alook how bis did it it might help

[General Barron]

Snypir's tut tells you how to use the LD in scripts. If you just want to use the LD to have an A10 drop bombs on a target, then check this thread here:

http://www.flashpoint1985.com/cgi-bin/ikonboard311/ikonboard.cgi?s=417403cace7067e058725d5289ac3f0c;act=ST;f=3;t=46269

In short, you just turn on the LD, then tell your plane to attack the laser target. Very simple to use, and very effective.